HOOD AIR INTAKE
HOOD
Exploded View
|
1. |
Hood air intake |
2. |
Hood panel |
3. |
Hood front seal |
|
4. |
Grommet |
5. |
Hood support rod |
6. |
Clamp |
|
7. |
Hood insulator |
8. |
Hood hinge |
9. |
Hood bumper rubber |
|
Refer to Components for the symbols shown in the figure. |
|||||
Removal and Installation
REMOVAL- 1.Remove the mounting clips, and then remove the hood insulator.
- 2.Remove the hood air intake mounting nuts.
- 3.Disengage the pawls from the hood panel.
 | : Pawl |
NOTE：
Press and remove the pawls from the access holes set to the panel. ■ CAUTION ■
Carefully disengage the pawls because they may be damaged if they are disengaged forcibly. - 4.Slide the hood air intake (1) toward vehicle front, and then lift up and remove it from the hood panel (2).
INSTALLATIONInstall in the reverse order of removal.
■ CAUTION ■
- Securely engage the pawls with the panel until it clicks.
- Check that the guide rib does not run on to the hood panel.
: Guide rib
