Nissan GT-R (R35) · Service Manual
RESTRAINTS
RESTRAINTS › SEAT BELT CONTROL SYSTEM › SYMPTOM DIAGNOSIS
SEAT BELT WARNING LAMP DOES NOT TURN ON
1.CHECK SELF DIAGNOSIS RESULT
Perform “COMBINATION METER” self diagnostic result. Refer to
CONSULT-III Function (METER/M&A)
Is DTC detected?
YES
>>
Repair or replace the malfunctioning parts.
NO
>>
GO TO 2
.
2.CHECK POWER SUPPLY
Check fuse are not blown.
Check ignition power supply of combination meter. Refer to
Diagnosis Procedure
Is the inspection result normal?
YES
>>
GO TO 3
.
NO
>>
Repair or replace the malfunctioning parts.
3.CHECK SEAT BELT BUCKLE SWITCH CIRCUIT (DRIVER SIDE)
Check seat belt buckle switch circuit (driver side). Refer to
Component Function Check
Is the inspection result normal?
YES
>>
GO TO 4
.
NO
>>
Repair or replace the malfunctioning parts.
4..CHECK SEAT BELT BUCKLE SWITCH CIRCUIT (PASSENGER SIDE)
Check seat belt buckle switch circuit (passenger side). Rer to
Component Function Check
Is the inspection result normal?
YES
>>
GO TO 5
.
NO
>>
Repair or replace the malfunctioning parts.
5..CHECK SEAT BELT WARNING LAMP CIRCUIT
Check seat belt warning lamp circuit. Rer to
Diagnosis Procedure
Is the inspection result normal?
YES
>>
GO TO 6
.
NO
>>
Repair or replace the malfunctioning parts.
6.CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES
>>
Check intermittent incident. Refer to
Intermittent Incident
.
NO
>>
GO TO 1
.
1.CHECK SELF DIAGNOSIS RESULT