BCM

Check that the following fuse and fusible link are not blown.

Signal name	Fuse and fusible link No.
Battery power supply	I
	10

YES>>Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown.

NO>>GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect BCM connectors.
3. Check voltage between BCM harness connector and ground.
   

   Terminals			Voltage (Approx.)
   (+)		(−)
   BCM		Ground
   Connector	Terminal
   M118	1		Battery voltage
   M119	11

   
   

YES>>GO TO 3.

NO>>Repair harness or connector.

Check continuity between BCM harness connector and ground.

BCM		Ground	Continuity
Connector	Terminal
M119	13		Existed

YES>>INSPECTION END

NO>>Repair harness or connector.