HEADLAMP
DIAGNOSIS SYSTEM (BCM)
WORK SUPPORT|
Service item |
Setting item |
Setting |
|
BATTERY SAVER SET |
On* |
With the exterior lamp battery saver function |
|
Off |
Without the exterior lamp battery saver function |
|
|
ILL DELAY SET |
MODE 1 |
NOTE：
The item is indicated, but not operated.
|
|
MODE 2 |
||
|
MODE 3 |
||
|
MODE 4 |
||
|
MODE 5 |
||
|
MODE 6 |
||
|
MODE 7 |
||
|
MODE 8 |
DATA MONITOR|
Monitor item [Unit] |
Description |
|
PUSH SW [On/Off] |
The switch status input from push-button ignition switch |
|
ENGINE STATE [Stop/Stall/Crank/Run] |
The engine status received from ECM with CAN communication |
|
VEH SPEED 1 [km/h] |
The value of the vehicle speed received from combination meter with CAN communication |
|
KEY SW-SLOT [On/Off] |
Key switch status input from key slot |
|
TURN SIGNAL R [On/Off] |
Each switch status that BCM judges from the combination switch reading function |
|
TURN SIGNAL L [On/Off] |
|
|
TAIL LAMP SW [On/Off] |
|
|
HI BEAM SW [On/Off] |
|
|
HEAD LAMP SW1 [On/Off] |
|
|
HEAD LAMP SW2 [On/Off] |
|
|
PASSING SW [On/Off] |
|
|
AUTO LIGHT SW [On/Off] |
NOTE：
The item is indicated, but not monitored.
|
|
FR FOG SW [On/Off] |
NOTE：
The item is indicated, but not monitored.
|
|
DOOR SW-DR [On/Off] |
The switch status input from driver side door switch |
|
DOOR SW-AS [On/Off] |
The switch status input from passenger side door switch |
|
DOOR SW-RR [On/Off] |
NOTE：
The item is indicated, but not monitored.
|
|
DOOR SW- RL [On/Off] |
NOTE：
The item is indicated, but not monitored.
|
|
DOOR SW-BK [On/Off] |
NOTE：
The item is indicated, but not monitored.
|
ACTIVE TEST|
Test item |
Operation |
Description |
|
TAIL LAMP |
On |
Transmits the position light request signal to IPDM E/R with CAN communication to turn the tail lamp ON. |
|
Off |
Stops the position light request signal transmission. |
|
|
HEAD LAMP |
Hi |
Transmits the high beam request signal with CAN communication to turn the headlamp (HI). |
|
Low |
Transmits the low beam request signal with CAN communication to turn the headlamp (LO). |
|
|
Off |
Stops the high & low beam request signal transmission. |
|
|
FR FOG LAMP |
On |
NOTE：
The item is indicated, but cannot be tested.
|
|
Off |
||
|
DAYTIME RUNNING LIGHT |
On |
Transmits the daytime running light request signal with CAN communication to turn the daytime running light. |
|
Off |
Stops the daytime running light request signal transmission. |
|
|
CORNERING LAMP |
RH |
NOTE：
The item is indicated, but cannot be tested.
|
|
LH |
||
|
Off |
||
|
ILL DIM SIGNAL |
On |
NOTE：
The item is indicated, but cannot be tested.
|
|
Off |