FLASHER
DIAGNOSIS SYSTEM (BCM)
WORK SUPPORT|
Service item |
Setting item |
Setting |
|
|
HAZARD ANSWER BACK |
Lock Only* |
With locking only |
Sets the hazard warning lamp answer back function when the door is lock/unlock with the request switch or the key fob. |
|
Unlk Only |
With unlocking only |
||
|
Lock/Unlk |
With locking/unlocking |
||
|
Off |
Without the function |
||
DATA MONITOR|
Monitor item [Unit] |
Description |
|
REQ SW-DR [On/Off] |
The switch status input from the request switch (driver side) |
|
REQ SW-AS [On/Off] |
The switch status input from the request switch (passenger side) |
|
PUSH SW [On/Off] |
The switch status input from the push-button ignition switch |
|
TURN SIGNAL R [On/Off] |
Each switch condition that BCM judges from the combination switch reading function |
|
TURN SIGNAL L [On/Off] |
|
|
HAZARD SW [On/Off] |
The switch status input from the hazard switch |
|
RKE-LOCK [On/Off] |
Lock signal status received from the remote keyless entry receiver |
|
RKE-UNLOCK [On/Off] |
Unlock signal status received from the remote keyless entry receiver |
|
RKE-PANIC [On/Off] |
Panic alarm signal status received from the remote keyless entry receiver |
ACTIVE TEST|
Test item |
Operation |
Description |
|
FLASHER |
RH |
Outputs the voltage to blink the right side turn signal lamps. |
|
LH |
Outputs the voltage to blink the left side turn signal lamps. |
|
|
Off |
Stops the voltage to turn the turn signal lamps OFF. |