ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
INSPECTION AND ADJUSTMENT
Description
BEFORE REPLACEMENTWhen replacing BCM, save or print current vehicle specification with CONSULT‐III configuration before replacement.
NOTE：
If “READ CONFIGURATION” can not be used, use the “WRITE CONFIGURATION - Manual selection” after replacing BCM. AFTER REPLACEMENT■ CAUTION ■
- When replacing BCM, you must perform “WRITE CONFIGURATION” with CONSULT‐III.
- Complete the procedure of “WRITE CONFIGURATION” in order.
- If you set incorrect “WRITE CONFIGURATION”, incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
- When replacing BCM, perform the system initialization (NATS).
1.SAVING VEHICLE SPECIFICATION
CONSULT-III Configuration