CONFIGURATION (BCM)

Vehicle specification needs to be written with CONSULT‐III because it is not written after replacing BCM.
Configuration has three functions as follows

NOTE：

Manual setting item: Items which need selection by vehicle specifications
Automatic setting item: Items which are written in automatically (Setting can not be changed)

Function	Description
READ CONFIGURATION	Reads the vehicle configuration of current BCM. Saves the read vehicle configuration.
WRITE CONFIGURATION - Manual selection	Writes the vehicle configuration with manual selection.
WRITE CONFIGURATION - Config file	Writes the vehicle configuration with saved data.

■ CAUTION ■

• When replacing BCM, you must perform “WRITE CONFIGURATION” with CONSULT‐III.
  
• Complete the procedure of “WRITE CONFIGURATION” in order.
  
• If you set incorrect “WRITE CONFIGURATION”, incidents might occur.
  
• Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
  
• Never perform “WRITE CONFIGURATION” except for new BCM.
  

■ CAUTION ■

Thoroughly read and understand the vehicle specification. Incorrect settings may result in abnormal control of ECU.

⇔: Items which confirm vehicle specifications

MANUAL SETTING ITEM		NOTE
Items	Setting value
DTRL	WITH ⇔ WITHOUT	WITH: With daytime running light system WITHOUT: Without daytime running light system

AUTO SETTING ITEM		NOTE
Items	Setting value
WELCOME LIGHT SELECT	WITHOUT	—
H/L BULB	DEFAULT	—
AUTO LIGHT	WITHOUT	—
FR FOG LAMP	WITH	Even on a vehicle without front fog lamp. It displays “WITH”.
RR FOG LAMP	WITH	Even on a vehicle without rear fog lamp. It displays “WITH”.
DI LMP VARIAT	MODE3	—
TRANSMISSION	TRANSMISSION	—
RAIN SENSOR	WITHOUT	—
HAZARD SW TYPE	MODE2	—
BCM AC CONTROL	MODE1	—
TPMS	TPMS SBF	—
RR WIPER GND	MODE1	—
DROP WIP FUNCTION	WITHOUT	—