Check that all of the following conditions are satisfied.
TESTING CONDITION

• Vehicle driven distance: More than 5,000 km (3,107 miles)
• Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm², 14.25 - 15.12 psi)
• Atmospheric temperature: 20 - 30°C (68 - 86°F)
• Engine coolant temperature: 75 - 95°C (167 - 203°F)
• Transmission: Warmed-up
• After the engine is warmed up to normal operating temperature, drive vehicle until “ATF TEMP SE 1” (A/T fluid temperature sensor signal) indicates more than 60°C (140°F).
• Electrical load: Not applied
• Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
• Engine speed: Idle

>>GO TO 2.

With CONSULT-III

NOTE：

Perform “SPEC” in “DATA MONITOR” mode in maximum scale display.

1. Perform Special Repair Requirement.
2. Select “B/FUEL SCHDL”, “A/F ALPHA-B1”, “A/F ALPHA-B2”, “MAS A/F SE-B1” and “MAS A/F SE-B2” in “SPEC” of “DATA MONITOR” mode with CONSULT-III.
3. Check that monitor items are within the SP value.

YES>>INSPECTION END

NO>>Go to Diagnosis Procedure.