1.CHECK ACCELERATOR PEDAL POSITION SENSOR
Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.
Check the voltage ECM harness connector terminals as follows.
ECM
Condition
Voltage (V)
Connector
+
–
Terminal
Terminal
M107
104 (APP sensor 1)
103
Accelerator pedal
Fully released
0.5 - 1.0
Fully depressed
4.2 - 4.8
108 (APP sensor 2)
107
Fully released
0.25 - 0.50
Fully depressed
2.0 - 2.5
Is the inspection result normal?
YES
>>
INSPECTION END
NO
>>
GO TO 2
.
2.REPLACE ACCELERATOR PEDAL ASSEMBLY
Replace accelerator pedal assembly.
Go to
Special Repair Requirement (GT-R certified NISSAN dealer)
.
>>
INSPECTION END
