REMOVAL

    1.Remove the engine under cover. Refer to Removal and Installation.
    2.Remove the clip connecting the front under cover and the fender protector (LH/RH) (front). Refer to Exploded View.
    3.Remove the bolt (front undercover rear edge) tightened together with the floor under cover.
    4.Remove the bolts (front under cover front edge) connecting the radiator core support.
    5.Remove the front under cover.
 
 INSTALLATION

Note the following, and install in the reverse order of removal.
■ CAUTION ■
  • Visually check the clips for deformation and damage at installation. Replace with new ones if necessary.
  • Always tighten the mounting bolts to the specified torque.