With CONSULT-III

1. Perform the “SELF-DIAGNOSIS”.
2. Check if any DTC is detected in the self-diagnostic results.

NOTE：

If DTC is displayed along with DTC U1000 or U1010, first diagnose the DTC U1000 or U1010. Refer to DTC Logic or DTC Logic.

YES>>Perform the diagnosis of air mix door motor system (driver side). Refer to Diagnosis Procedure.

NO>>GO TO 2.

1. Turn temperature dial (driver side) and raise temperature setting to 32.0°C (90°F) after warming up the engine.
2. Check that warm air blows from outlets.
3. Operate the compressor.
4. Operate the temperature control dial (driver side) and lower the set temperature to 18.0°C (60°F).
5. Check that the cool air blows from the outlets.

YES>>INSPECTION END

NO>>Check the air mix door motor system (driver side) installation condition. Repair or replace the malfunctioning parts.