With CONSULT-III

1. Perform the “SELF-DIAGNOSIS”.
2. Check if any DTC is detected in the self-diagnostic results.

NOTE：

If DTC is displayed along with DTC U1000 or U1010, first diagnose the DTC U1000 or U1010. Refer to DTC Logic or DTC Logic.

YES>>Perform the diagnosis of intake door motor system. Refer to Diagnosis Procedure.

NO>>GO TO 2.

1. Press REC switch to set the air outlet to recirculation.
2. The REC switch indicator turns on.
3. Listen to intake sound and confirm air inlets change.
4. Press FRE switch to set the air outlet to fresh air intake.
5. The FRE switch indicator turns on.
6. Listen to intake sound and confirm air inlets change.

YES>>INSPECTION END

NO>>Check the intake door system installation condition. Repair or replace the malfunctioning parts.