1.PERFORM CALIBRATION OF PRESSURE SENSOR
Select “PRESS SEN CALIBRATION” in “WORK SUPPORT”, and perform pressure sensor calibration.
>>
GO TO 2
.
2.PERFORM CALIBRATION OF VALVE
Select “VALVE CALIBRATION” in “WORK SUPPORT”, and perform valve calibration.
Is calibration of valve finished?
YES
>>
INSPECTION END
NO
>>
GO TO 3
.
3.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Perform ABS actuator and electric unit (control unit) self-diagnosis.
Is DTC “C1193” detected?
YES
>>
Replace ABS actuator and electric unit (control unit).
NO
>>
Repair or replace error-detected parts.