- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Disconnect the following harness connectors.
- ECM
- Steering angle sensor
- Check the continuity between the steering angle sensor harness connector and the data link connector.
Steering angle sensor harness connector
| Data link connector
| Continuity
|
Connector No.
| Terminal No.
| Connector No.
| Terminal No.
|
M37
| 5
| M24
| 6
| Existed
|
2
| 14
| Existed
|
Is the inspection result normal?
YES (Present error)
>>Connect all the connectors and diagnose again. Refer to
Trouble Diagnosis Flow Chart.
YES (Past error)
>>Error was detected in the main line between the steering angle sensor and the data link connector.
NO
>>Repair the main line between the steering angle sensor and the data link connector.