1.CHECK “ANTI KEY LOCK IN FUNCTI” SETTING IN “WORK SUPPORT”
Check “ANTI KEY LOCK IN FUNCTI” setting in “WORK SUPPORT”.
Refer to
CONSULT-III Function (BCM - INTELLIGENT KEY)
.
Is the inspection result normal?
YES
>>
GO TO 2
.
NO
>>
Set “ANTI KEY LOCK IN FUNCTI” setting in “WORK SUPPORT”.
2.CHECK DOOR SWITCH
Check door switch.
Refer to
Component Function Check
.
Is the inspection result normal?
YES
>>
GO TO 3
.
NO
>>
Repair or replace the malfunctioning parts.
3.CHECK INSIDE KEY ANTENNA
Check inside key antenna.
Refer to
DTC Logic
(instrument center).
Refer to
DTC Logic
(console).
Refer to
DTC Logic
(trunk room).
Is the inspection result normal?
YES
>>
GO TO 4
.
NO
>>
Repair or replace the malfunctioning parts.
4.CHECK UNLOCK SENSOR
Check unlock sensor.
Refer to
Component Function Check
.
Is the inspection result normal?
YES
>>
GO TO 5
.
NO
>>
Repair or replace the malfunctioning parts.
5.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>>
Check intermittent incident. Refer to
Intermittent Incident
.
NO
>>
GO TO 1
.