1.CHECK “LO- BATT OF KEY FOB WARN” SETTING IN “WORK SUPPORT”
Check “LO- BATT OF KEY FOB WARN” setting in “WORK SUPPORT”.
Refer to
CONSULT-III Function (BCM - INTELLIGENT KEY)
.
Is the inspection result normal?
YES
>>
GO TO 2
.
NO
>>
Set “LO- BATT OF KEY FOB WARN” setting in “WORK SUPPORT”.
2.CHECK INTELLIGENT KEY BATTERY
Check Intelligent Key battery.
Refer to
Component Function Check
.
Is the inspection result normal?
YES
>>
GO TO 3.
NO
>>
Repair or replace the malfunctioning parts.
3.CHECK COMBINATION METER DISPLAY
Check combination meter display.
Refer to
Component Function Check
.
Is the inspection result normal?
YES
>>
GO TO 4
.
NO
>>
Repair or replace the malfunctioning parts.
4.CHECK INSIDE KEY ANTENNA
Check inside key antenna.
Refer to
DTC Logic
(instrument center).
Refer to
DTC Logic
(console).
Refer to
DTC Logic
(trunk room).
Is the inspection result normal?
YES
>>
GO TO 5
.
NO
>>
Repair or replace the malfunctioning parts.
5.CHECK KEY SLOT ILLUMINATION
Check key slot illumination.
Refer to
Component Function Check
.
Is the inspection result normal?
YES
>>
GO TO 6
.
NO
>>
Repair or replace the malfunctioning parts.
6.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>>
Check intermittent incident. Refer to
Intermittent Incident
.
NO
>>
GO TO 1
.