Disconnect the Air Suction Valve (ASV) hose from the ASV (49 state 2WD carburetor
model only).
Disconnect the rear exhaust pipe from the front exhaust pipe (non-turbo),
center exhaust pipe (turbocharged models).
Disconnect the rear exhaust pipe from the muffler assembly. To prevent damage
to the bumper or rear skirt by the muffler, wrap a cloth around the tail pipe.
Remove rear exhaust pipe from the rubber cushion. To help in its removal,
apply a coat of CRC® 5–56 to the mating surface of the rubber
cushion in advance.
To install:
Temporarily connect the rear exhaust pipe and the muffler assembly.
Temporarily connect the rear exhaust pipe and the front exhaust pipe (non-turbo),
center exhaust pipe (turbocharged models).
Insert exhaust pipe bracket into the rubber cushion. To aid in installation,
apply a coat of CRC® 5–56 to the mating surface of the rubber
cushion in advance.
Adjust the clearance between the temporarily installed parts and tighten
to specified torque.
WARNING
Be sure to install bolts, springs, and self locking nuts in the order indicated
in figure 91. Always install new self locking nuts.
