ADJUSTMENT

1. Disconnect the linkage rod from the transaxle manual lever.

   NOTE: Refer to the illustration of the shift linkage system earlier in this section.

2. Make sure that the manual lever on the transaxle is in the neutral detent position.
3. Remove the manual lever by taking off the mounting nut.
4. Remove the two safety switch mounting bolts and the setscrew from the lower face of the switch.
5. Insert a 1.5mm drill bit through the set screw hole. Turn the switch slightly so that the drill bit passes through into the back part of the switch.
6. Bolt the switch in place and remove the drill bit.
7. Reinstall the setscrew and the manual lever.
8. Connect the linkage rod and adjust, if necessary, according to the procedure given earlier in this section.