Antenna

REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.
2. Disconnect the antenna wire from the radio.
3. Push the antenna wire through the access hole under the instrument panel.

   NOTE: To make installation easier, tie a string to the end of the antenna wire before removing it from the vehicle. Pull the string up with the antenna wire and allow one end to stay visible at the inside of the vehicle. When installing the antenna, tie the wire to the other end of the string and pull it through.

4. On models with the antenna on the side of the windshield:
   1. Remove the A pillar trim.
   2. Loosen the antenna mounting nut located beneath the trim panel.
   3. Move the antenna upward slightly then pull it out of the pillar with the antenna lead.
5. On models with roof mounted antenna, remove the antenna base mounting screw and pull the antenna off of the roof, drawing the wire out of the opening.

   To install:

6. Install the antenna in position, guiding the wire into position. Install the antenna base plate, making sure it is flush with the body.
7. Connect the wire to the radio and check the operation.
8. Install any removed trim.