REMOVAL & INSTALLATION

Justy and Loyale

The VSS is inside the meter assembly. The speedometer should be replaced if the VSS is found to be defective.

Impreza

VSS1

The VSS1 is located inside the transaxle; no removal and installation is possible.

VSS2

The VSS2 is inside the meter assembly. The speedometer should be replaced if the VSS is found to be defective.

Legacy

VSS1

1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle on jackstands.
3. At the transaxle case, disconnect the electrical harness from the VSS1.
4. Remove the VSS-to-case bolt and the VSS.
5. Installation is the reverse of removal. Secure all components accordingly.

VSS2

The VSS2 is inside the meter assembly. The speedometer should be replaced if the VSS is found to be defective.

SVX

VSS1

1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle on jackstands.
3. At the transaxle case, disconnect the electrical harness from the VSS1.
4. Remove the VSS-to-case bolt and the VSS.

   To install:

5. Install VSS, and tighten the bolt snugly. Attach the harness to the VSS.
6. Connect the negative battery cable.

VSS2

1. Disconnect the negative battery cable.
2. Disconnect the electrical harness from the VSS2.
3. Pull the VSS from the torque converter case.
4. Installation is the reverse of removal. Secure all components accordingly.