Before servicing any vehicle, please be sure to read all of the following precautions
that deal with personal safety, prevention of component damage, and important
points to take into consideration when servicing a motor vehicle:
- Never open, service or drain the radiator or cooling system when the engine
is hot; serious burns can occur from the steam and hot coolant.
- Observe all applicable safety precautions when working around fuel. Whenever
servicing the fuel system, always work in a well-ventilated area. Do not allow
fuel spray or vapors to come in contact with a spark, open flame, or excessive
heat (a hot drop light, for example). Keep a dry chemical fire extinguisher
near the work area. Always keep fuel in a container specifically designed
for fuel storage; also, always properly seal fuel containers to avoid the
possibility of fire or explosion. Refer to the additional fuel system precautions
later in this section.
- Fuel injection systems often remain pressurized, even after the engine has
been turned OFF . The fuel system pressure must be relieved
before disconnecting any fuel lines. Failure to do so may result in fire and/or
personal injury.
- Brake fluid often contains polyglycol ethers and polyglycols. Avoid contact
with the eyes and wash your hands thoroughly after handling brake fluid. If
you do get brake fluid in your eyes, flush your eyes with clean, running water
for 15 minutes. If eye irritation persists, or if you have taken brake fluid
internally, IMMEDIATELY seek medical assistance.
- The EPA warns that prolonged contact with used engine oil may cause a number
of skin disorders, including cancer. You should make every effort to minimize
your exposure to used engine oil. Protective gloves should be worn when changing
oil. Wash your hands and any other exposed skin areas as soon as possible
after exposure to used engine oil. Soap and water, or waterless hand cleaner
should be used.
- All new vehicles are now equipped with an air bag system. The system must
be disabled before performing service on or around system components, steering
column, instrument panel components, wiring and sensors. Failure to follow
safety and disabling procedures could result in accidental air bag deployment,
possible personal injury, and unnecessary system repairs.
- Always wear safety goggles when working with, or around, the air bag system.
When carrying a non-deployed air bag, be sure the bag and trim cover are pointed
away from your body. When placing a non-deployed air bag on a work surface,
always face the bag and trim cover upward, away from the surface. This will
reduce the motion of the module if it is accidentally deployed. Refer to the
additional air bag system precautions later in this section.
- Clean, high quality brake fluid from a sealed container is essential to
the safe and proper operation of the brake system. You should always buy the
correct type of brake fluid for your vehicle. If the brake fluid becomes contaminated,
completely flush the system with new fluid. Never reuse any brake fluid. Any
brake fluid that is removed from the system should be discarded. Also, do
not allow any brake fluid to come in contact with a painted surface; it will
damage the paint.
- Never operate the engine without the proper amount and type of engine oil;
doing so will result in severe engine damage.
- Timing belt maintenance is extremely important. Many models utilize an interference-type,
non-freewheeling engine. If the timing belt breaks, the valves in the cylinder
head may strike the pistons, causing potentially serious (also time-consuming
and expensive) engine damage. Refer to the maintenance interval charts in
the front of this manual for the recommended replacement interval for the
timing belt, and to the timing belt section for belt replacement and inspection.
- Disconnecting the negative battery cable on some vehicles may interfere
with the functions of the on-board computer system(s) and may require the
computer to undergo a relearning process once the negative battery cable is
reconnected.
- When servicing drum brakes, only disassemble and assemble one side at a
time, leaving the remaining side intact for reference.
