Previous Next

Fuel System Pressure

RELIEVING

1997 Vehicles

NOTE: This procedure must be performed prior to servicing any component of the fuel injection system.

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove the rear seat, then pull the floor mat up.
  3. Detach the fuel pump harness from the fuel tank.
  4. Crank the engine for 5 seconds or more to relieve the fuel pressure. If the engine starts during this time, allow it to run until it stalls.
  5. After performing the required service, connect the fuel pump harness.
1998–01 Vehicles

NOTE: This procedure must be performed prior to servicing any component of the fuel injection system.

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Disconnect the fuel pump connector from the fuel pump relay.
  3. Crank the engine for 5 seconds or more to relieve the fuel pressure. If the engine starts during this time, allow it to run until it stalls.
  4. After performing the required service, connect the fuel pump harness.

Previous Next