Removal & Installation

To Remove:

1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
2. Remove or disconnect the following:
   • Ground cable from battery

     Crank Position Sensor

   • Crankshaft position sensor connector
   • Crankshaft position sensor to cylinder block bolt
   • Crankshaft position sensor

To Install:

1. Install or connect the following:

   Crank Position Sensor

   • Crankshaft position sensor
   • Crankshaft position sensor to cylinder block bolt
     1. Torque to: 4.7 ft. lbs. (6.4 Nm)
   • Crankshaft position sensor connector
   • Ground cable from battery