Brake Caliper

Removal & Installation

To Remove:

1. Jack-up vehicle and support it with safety stands
2. Remove or disconnect the following
   • Wheel

   • Union bolt
   • Brake hose from caliper body assembly

     CAUTION
     Do not spill brake fluid on painted surface. If fluid is spilled, wash it off immediately.

   • Lock pin to caliper body bolt
   • Caliper body and move it toward vehicle center to separate it from support

To Install:

1. Install the following
   • Caliper body on support
   • Torque specification: 39 Nm (28.9 ft. lbs.)

   • Brake hose
   • Torque specification: 18 Nm (13.0 ft. lbs.)

   CAUTION
   Replace brake hose gaskets with new ones.

2. Bleed air from brake system