1. Install the select cable to plate assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2. Install the select cable to the range select lever.
3. Install the plate assembly to the transmission.
Tightening torque:
T: 24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
|
(A) |
Select cable |
|
(B) |
Plate ASSY |
4. Install the washer and snap pin to range select lever.
|
(A) |
Select lever |
|
(B) |
Snap pin |
|
(C) |
Select cable |
|
(D) |
Clamp |
|
(E) |
Washer |
5. Move the select lever to the “N” range, then adjust the select cable position. 
6. Install the heat shield cover. (If equipped)
7. Install the front and center exhaust pipe.
Non-turbo model
Turbo model