| CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from ECM. 3) Disconnect the connectors from accelerator pedal position sensor. 4) Measure the resistance between accelerator pedal position sensor connectors. Connector & terminal (B135) No. 6 — (B315) No. 3: |
| QUESTION | |
|
Is the resistance more than 1 MΩ? | |
| Yes | No |
|
Repair the poor contact of ECM connector. Replace the ECM if defective. |
Repair the open circuit of harness between ECM connector and accelerator pedal position sensor connector. |
