| CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from ECM. 3) Disconnect the connectors from accelerator pedal position sensor. 4) Measure the resistance between connector terminals of accelerator pedal position sensor. Connector & terminal (B315) No. 6 — (B315) No. 3: |
| QUESTION | |
|
Is the resistance more than 1 MΩ? | |
| Yes | No |
|
Repair the poor contact of ECM connector. Replace the ECM if defective. |
Repair the short circuit of harness between ECM connector and accelerator pedal position sensor connector. |
