TCM and Clutch Initialization

NOTE:

After reinstalling the parts in the following table, except ECM. TCM and smart drive unit, perform “Accumulator Replacement”.

1)Select learning procedure in the following table.

Replacement	Initialization
ECM	ECM Replacement
TCM	TCM Replacement
Electric motor with oil pump, accumulator, hydraulic system filter, oil pipes and twin clutch system actuation fluid reservoir all together at the same time (except smart drive unit and solenoid valve unit with sensor module)	Hydraulic KIT Replacement
Transaxle assembly or transaxle inner parts	Gearbox Replacement
Electric motor	Oil Pump Replacement
Solenoid valve unit with sensor module and even clutch pressure sensor	•Electro valve Replacement •Sensor module Replacement •K2 clutch pressure sensor Replacement
Odd gear clutch control actuator	K1 clutch position sensor Replacement
•Odd gear clutch assembly •Even gear clutch assembly •Even gear clutch control actuator	Clutch KIT Replacement
•Accumulator •Oil pipe •Twin clutch system actuation fluid reservoir •Hydraulic system filter	Accumulator Replacement
Smart drive unit	SDU Replacement

2)Perform selected initialization procedure as follows.
All learning value initialization:

a)Set ignition “OFF”.

b)Connect SUZUKI scan tool to DLC (1).

Special Tool

c)Set ignition “ON”.

d)Check that transmission warning light does not come on and DTC is not detected in TCM.

e)Select each of function under “Utility” mode on SUZUKI scan tool, and follow the instruction displayed on SUZUKI scan tool.