Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > BASIC INSPECTION

for Preparation Click here


When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.


1.CHECK BATTERY VOLTAGE

    NOTICE:
    Perform this check with the engine stopped and ignition switch OFF.

    Result
    Proceed to
    11 V or more
    OK
    Below 11 V
    NG


NG.
CHARGE OR REPLACE BATTERY
OK


2.CHECK WHETHER ENGINE WILL CRANK


    NG.
    PROCEED TO PROBLEM SYMPTOMS TABLE
    OK


    3.CHECK WHETHER ENGINE STARTS


      NG.
      GO TO STEP 6
      OK


      4.CHECK AIR FILTER
      1. Visually check that the air filter is not excessively contaminated with dirt or oil.



      NG.
      REPLACE AIR FILTER
      OK


      5.CHECK IDLING SPEED
      1. Check the idling speed .



      NG.
      PROCEED TO PROBLEM SYMPTOMS TABLE
      OK


      6.CHECK FUEL PRESSURE
      1. Check the fuel pressure .



      NG.
      PROCEED TO TROUBLESHOOTING
      OK


      7.CHECK FOR SPARK
      1. Check for spark .



      NG.
      PROCEED TO TROUBLESHOOTING
      OK

      PROCEED TO PROBLEM SYMPTOMS TABLE