DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2102 | Following conditions are met for 2 seconds (1 trip detection logic):
|
|
| P2103 | Either of the following condition is met:
|
|
| Related DTCs | P2102: Throttle actuator current (low current) P2103: Throttle actuator current (high current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle body) |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor will run whenever these DTCs are not present | None |
| Throttle actuator | ON |
| Duty ratio to open throttle actuator | 80 % or more |
| Throttle power supply | 8 V or more |
| Motor current change during latest 0.016 seconds | Less than 0.2 A |
| Throttle actuator | ON |
| Either of the following conditions is met: | Condition 1 or 2 |
| 1. Throttle actuator power supply | 8 V or more |
| 2. Throttle actuator power | ON |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Throttle actuator current | Less than 0.5 A (when motor drive duty 80 % or more) |
| When either condition below is met: | Condition 1 or 2 |
| 1. Hybrid IC diagnosis signal | Fail |
| 2. Hybrid IC current limiter port | Fail |
| 1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
![]() |
Disconnect the T2 throttle body assembly connector.
Measure the resistance of the throttle actuator.
| Tester Connection | Specified Condition |
| M+ (T2-2) - M- (T2-1) | 0.3 to 100 Ω at 20°C (68°F) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM) |
![]() |
Disconnect the T2 throttle body assembly connector.
Disconnect the E4 ECM connector.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| M+ (T2-2) - M+ (E4-5) | Below 1 Ω |
| M- (T2-1) - M- (E4-4) | |
| M+ (T2-2) or M+ (E4-5) - Body ground | 10 kΩ or higher |
| M- (T2-1) or M- (E4-4) - Body ground |
Reconnect the ECM connector.
Reconnect the throttle body assembly connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check between the throttle valve and the housing for foreign objects. Also check if the valve can open and close smoothly.
|
| ||||
| OK | ||
| ||