DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|
| Related DTCs | P2118: Throttle actuator power supply |
| Required Sensors/Components | Throttle actuator, throttle valve, ETCS fuse |
| Frequency of Operation | Continuous |
| Duration | 0.8 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Actuator power | ON |
| Throttle actuator power supply voltage (+BM) | Less than 4 V |
| Throttle actuator power supply voltage | 9 to 14 V |

| 1.INSPECT FUSE (ETCS) |
![]() |
Remove the ETCS fuse from the engine room relay block.
Measure the resistance of the ETCS fuse.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 2.READ VALUE OF INTELLIGENT TESTER (+BM VOLTAGE) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / +BM.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Remove the ETCS fuse from the engine room relay block.
Disconnect the E8 ECM connector.
Measure the resistance of the wire harness side connector between the ETCS fuse and ECM.
| Tester Connection | Specified Condition |
| Engine Room R/B (ETCS fuse terminal) - +BM (E8-7) | Below 1 Ω |
| Engine Room R/B (ETCS fuse terminal) or +BM (E8-7) - Body ground | 10 kΩ or higher |
Disconnect the battery positive terminal.
Measure the resistance of the wire harness side connector between the ETCS fuse and battery.
| Tester Connection | Specified Condition |
| Engine Room R/B (ECTS fuse terminal) - Battery positive terminal | Below 1 Ω |
| Engine Room R/B (ETCS fuse terminal) or Battery positive terminal - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the ETCS fuse.
|
| ||||
| OK | ||
| ||