Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
The ECU controls the cruise control system of the vehicle. The data and DTCs relating to the cruise control system can be read from the DLC3 of the vehicle. If CRUISE MAIN indicator light does not come on after the DTC check, there is a malfunction on the cruise control system.

CHECK DLC3
H100769E16
  1. The ECM uses the ISO 9141-2 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 9141-2 format.

    Symbols (Terminals No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus "+" line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    11 to 14 V
    CANH (6) - CANL (14)
    HIGH-level CAN bus line
    Ignition switch OFF
    54 to 67 Ω
    CANH (6) - CG (4)
    HIGH-level CAN bus line
    Ignition switch OFF
    1 MΩ or higher
    CANL (14) - CG (4)
    HIGH-level CAN bus line
    Ignition switch OFF
    3 kΩ or higher
    CANH (6) - BAT (16)
    LOW-level CAN bus line
    Ignition switch OFF
    1 MΩ or higher
    CANL (14) - BAT (16)
    LOW-level CAN bus line
    Ignition switch OFF
    3 kΩ or higher

    HINT:
    Connect the cable of the intelligent tester to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem with either the vehicle or the tester.
    1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
    2. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.


CHECK INDICATOR


    I033556E01
  1. Turn the ignition switch to ON.



  2. Check that the CRUISE main indicator light illuminates when the cruise control main switch is turned on, and that the indicator light turns off when the main switch is turned off. If the results are not as specified, inspect the CRUISE main indicator light circuit (Click here).

    HINT:
    BE04034E01
    While driving with cruise control, the ECM activates AUTO CANCEL of the cruise control system when a malfunction occurs in one of the following: vehicle speed sensors, stop light switch, or other related parts. When AUTO CANCEL is activated, the CRUISE main indicator light outputs the blinking pattern shown to the left. At the same time, data of the malfunction is stored as a DTC.