Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display does not Dim when Light Control Switch is Turned ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IMAGE QUALITY SETTING


    E125813
  1. Enter the display adjustment screen by pressing the "DISPLAY" switch.

  1. Turn the light control switch to the TAIL position.

  1. Check if "DAY MODE" on the display adjustment is ON.

    OK:
    "DAY MODE" is ON.



NG
Go to step 2
OK

TURN "DAY MODE" SETTING OFF 

2.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)


    E125810E01
  1. Enter the "Display Check" mode (Vehicle Signal Check) (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    TAIL or ON
    ON
    OFF
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPLACE RADIO AND NAVIGATION ASSEMBLY