IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK IGNITION COIL ASSEMBLY AND PERFORM SPARK TEST |
Check for DTCs.
Check that sparks occur.
Remove the ignition coils.
Using a 16 mm (0.63 in.) plug wrench, remove the spark plugs.
Install the spark plugs to each ignition coil, and connect the ignition coil connectors.
Disconnect the 6 injector connectors.
Ground the spark plugs.
Check if sparks occur at each spark plug while the engine is being cranked.
Spark test flow chart.
Check that the wire harness side connector of ignition coil assembly is securely connector.
| Result | Proceed to |
| NG | Connect securely. |
| OK | Go to next step. |
Perform spark test on each ignition coil assembly.
| Result | Proceed to |
| NG | Replace ignition coil assembly. |
| OK | Go to next step. |
Check power supply to ignition coil.
| Result | Proceed to |
| NG | Check wiring between ignition switch and ignition coil assembly. |
| OK | Go to next step. |
Check resistance in VVT sensor out put voltage (see step 2).
| Result | Proceed to |
| NG | Following test 1. |
| OK | Go to next step. |
| Result | Proceed to |
| NG | Repair wiring between VVT sensor and ECM. |
| OK | Repair VVT sensor |
Check resistance in crankshaft position sensor.
| Standard condition | Specified condition |
| Cold | 1,630 to 2,740 Ω |
| Hot | 2,065 to 3,225 Ω |
| Result | Proceed to |
| NG | Replace the crankshaft position sensor. |
| OK | Go to next step. |
Check IGT signal from ECM.
| Result | Proceed to |
| NG | Check ECM |
| OK | Repair wiring between ignition coil and ECM. |
Using a 16 mm (0.63 in.) plug wrench, install the spark plugs.
Install the ignition coils.
| 2. CHECK VVT SENSOR OUTPUT VOLTAGE |
Turn the ignition switch to the ON position.
Check that the voltage between terminal VC1 and ground is 5 V.
While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the Hi range and Lo range shown in the table below.
| Sensor position | Terminal No. | Voltage (Hi) | Voltage (Lo) |
| Bank 1 | VV1+ ←→ VV1- | 3.375 to 4.950 | 0.450 to 1.375 |
| Bank 2 | VV2+ ←→ VV2- | 3.375 to 4.950 | 0.450 to 1.375 |