Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > FAIL-SAFE CHART

for Preparation Click here


HINT:
If any of the following codes are recorded, the ECM enters the fail-safe mode.


DTC No.
Fail-Safe Operation
Fail-Safe Deactivation Conditions
P0031, P0032, P0037, P0038, P0051, P0052, P0057 and P0058
The heater circuit in which an abnormality is detected is turned off
Ignition switch OFF
P0100, P0102 and P0103
Ignition timing is calculated from engine RPM and TP (Throttle Position)
"Pass" condition detected
P0110, P0112 and P0113
IAT (Intake Air Temperature) is fixed at 20°C (68°F)
"Pass" condition detected
P0115, P0117 and P0118
ECT (Engine Coolant Temperature) is fixed at 80°C (176°F)
"Pass" condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
If the Electronic Throttle Control System (ETCS) has a malfunction, the ECM cuts off current to the throttle control motor. The throttle control valve returns to a predetermined opening angle (approximately 16°) by the force of the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle to enable the vehicle to continue at a minimal speed.
If the accelerator pedal is depressed firmly and slowly, the vehicle can be driven slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
"Pass" condition detected and then the ignition switch turned OFF
P0327, P0328, P0332 and P0333
Maximum ignition timing retardation
Ignition switch OFF
P0351, P0352, P0353, P0354, P0355, P0356, P0357 and P0358
Fuel is cut
"Pass" condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
The accelerator pedal position sensor has two (main and sub) sensor circuits. If a malfunction occurs in either of the sensor circuits, the ECM detects the abnormal signal voltage difference between the two sensor circuits and switches to limp mode. In limp mode, the functioning circuit is used to calculate the accelerator pedal opening angle to allow the vehicle to continue driving. If both circuits malfunction, the ECM regards the opening angle of the accelerator pedal to be fully closed. In this case, the throttle valve will remain closed as if the engine is idling.
"Pass" condition detected and then the ignition switch turned OFF
P2440 and P1441 and/or P1444
Restrict the throttle opening angle: Ga is 30, 50, 100 g/sec or less
"Pass" condition detected
P1441 and P1444
Restrict the throttle opening angle: Ga is 30, 50, 100 g/sec or less
"Pass" condition detected
P1441 and P1444
Restrict the throttle opening angle: Ga is 30, 50, 100 g/sec or less
"Pass" condition detected
P2430, P2431, P2432 and P2433
Restrict the throttle opening angle: Ga is 30, 50, 100 g/sec or less
"Pass" condition detected