AIR CONDITIONING SYSTEM > CHECK MODE PROCEDURE |
| LIST OF OPERATION METHODS |
By operating each of the A/C control switches as shown in the diagram below, it is possible to enter the diagnostic check mode.

| INDICATOR CHECK |
Turn the ignition switch off.
Turn the ignition switch on while pressing the A/C control "AUTO" switch and "R/F" switch simultaneously.
![]() |
SR-5 grade:
![]() |
Limited grade:
![]() |
The indicator check is automatically performed when panel diagnosis is activated. Check that the indicators light up and go off at 1 second intervals 4 times in succession.
| DTC CHECK (SENSOR CHECK) |
Start the engine and warm it up.
Perform the indicator check.
Push the "R/F" switch to perform the actuator check.
![]() |
If the steps are difficult to read because they change automatically, push the "FRONT DEF" switch to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the "FRONT DEF" switch is pushed.
Read the code displayed on the panel.
| ACTUATOR CHECK |
Start the engine and warm it up.
Perform the indicator check.
![]() |
Push the "R/F" switch to perform the actuator check.
![]() |
As the actuator check is repeated from steps 1 to 10 at 1 second intervals, check the temperature and air flow visually and by hand.
| Step No. | Display Code | Conditions | ||||
| Blower Level | Air Flow Vent | Air Inlet Damper | Magnetic clutch | Air Mix Damper | ||
| 1 | 0 | 0 | FACE | RECIRCULATION | OFF | "COLD" side (Fully closed) |
| 2 | 1 | 1 | FACE | RECIRCULATION | OFF | "COLD" side (Fully closed) |
| 3 | 2 | 17 | B/L | FRESH/ RECIRCULATION | ON | "COLD" side (Fully closed) |
| 4 | 3 | 17 | B/L | FRESH/ RECIRCULATION | ON | "COLD"/ "HOT" (50 % open) |
| 5 | 4 | 17 | FOOT | FRESH | ON | "COLD"/ "HOT" (50 % open) |
| 6 | 5 | 17 | FOOT | FRESH | ON | "COLD"/ "HOT" (50 % open) |
| 7 | 6 | 17 | FOOT | FRESH | ON | "HOT" side (Fully opened) |
| 8 | 7 | 17 | FOOT/ DEF | FRESH | ON | "HOT" side (Fully opened) |
| 9 | 8 | 17 | FOOT/ DEF | FRESH | ON | "HOT" side (Fully opened) |
| 10 | 9 | 31 | DEF | FRESH | ON | "HOT" side (Fully opened) |
![]() |
If the steps are difficult to read because they change automatically, push the "FRONT DEF" switch to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the "FRONT DEF" switch is pushed.