DTC P0230 Fuel Pump Primary Circuit |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0230 | Open or short in fuel pump relay circuit |
|

| 1.INSPECT ECM (FPR VOLTAGE) |
![]() |
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| FPR (E6-30) - E1 (E6-1) | STA signal ON | 9 to 14 V |
| FPR (E6-30) - E1 (E6-1) | STA signal OFF | 0 to 3 V |
|
| ||||
| OK | |
| 2.INSPECT FUEL PUMP RELAY |
![]() |
Remove the fuel pump relay from the engine room R/B.
Measure the resistance of the fuel pump relay.
| Tester Connection | Specified Condition |
| 3 - 4 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher |
| 3 - 4 | 10 kΩ or higher (when battery voltage applied to terminals 1 and 2) |
| 3 - 5 | Below 1 Ω (when battery voltage applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FUEL PUMP RELAY - ECM) |
![]() |
Remove the fuel pump relay from the engine room R/B.
Disconnect the E6 ECM connector.
Measure the resistance between wire harness side connectors.
| Tester Connections | Specified Conditions |
| Fuel pump relay (1) - FPR (E6-30) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Fuel pump relay (1) or FPR (E6-30) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the fuel pump relay.
|
| ||||
| OK | ||
| ||