DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | (1) If THW or THA is less than -6.6°C (20°F) at engine start and 20 minutes or more after starting engine, engine coolant temperature sensor value is 20°C (68°F) or less (2 trip detection logic) (2) If THW and THA is between -6.6°C (20°F) and 10°C (50°F) at engine start, 129 seconds or more after starting engine and engine coolant temperature sensor value is 20°C (68°F) or less (2 trip detection logic) (3) If THW and THA are greater than 10°C (50°F) at engine start and 77 seconds or more after starting engine, engine coolant temperature sensor value is 20°C (68°F) or less (2 trip detection logic) |
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors/Components (Main) | Thermostat, Cooling system |
| Required Sensors/Components (Related) | Engine coolant temperature sensor, Mass air flow meter |
| Frequency of Operation | Continuous |
| Duration | 77 seconds: -8.34°C (16.98°F) or more 129 seconds: -19.45 to -8.34°C (-3.01 to 16.98°F) 1200 seconds: Less than -19.45°C (-3.01°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever this DTC is not present | P0100 - P0103 (MAF sensor) P0110 - P0113 (IAT sensor) P0115 - P0118 (ECT sensor) |
| Engine | Running |
| Fuel cut | OFF |
| Time until "engine coolant temperature" detection temperature reaches feedback start temperature | - |
| When the temperature at the time of engine starting is -8.34°C (17°F) or more | Engine coolant temperature is less than "closed-loop enable temperature" when 77 sec. or more after engine start |
| When the temperature at the time of engine starting is -19.45 to -8.34°C (-3 to 17°F) | Engine coolant temperature is less than "closed-loop enable temperature" when 129 sec. or more after engine start |
| When the temperature at the time of engine starting is -19.45°C (-3°F) or less | Engine coolant temperature is less than "closed-loop enable temperature" when 20 min. or more after engine start |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0125 | A |
| P0125 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Check the valve opening temperature of the thermostat .
Reinstall the thermostat (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check that there is a defect in the cooling system which causes overcool, such as abnormal radiator fan operation, modified cooling system and so on.
|
| ||||
| OK | ||
| ||