AIR CONDITIONING SYSTEM > IG Power Source Circuit |

| 1.INSPECT FUSE (IG1) |
![]() |
Remove the IG1 fuse from the driver side J/B.
Measure the resistance according to the value(s) in the table below.
| Tester Item | Condition | Specified Condition |
| IG1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT AIR CONDITIONING AMPLIFIER (IG+ - GND) |
![]() |
Remove the A/C amplifier with the connectors still connected.
Turn the ignition switch ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| A16-1 (IG+) - A16-5 (GND) | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY) |
![]() |
Disconnect the connector from the A/C amplifier.
Measure the voltage according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| A16-1 (IG+) - Body ground | Ignition switch OFF | Below 1 V |
| A16-1 (IG+) - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A16-5 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||