Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Back-up Power Source Circuit

for Preparation Click here


DESCRIPTION

The back-up power source circuit for the A/C amplifier is shown below. Power is supplied even when turning the engine switch off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM


I033601E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)


    F043247E04
  1. Remove the ECU-B fuse from the engine room R/B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    ECU-B fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (ECU-B)
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)


    I033524E03
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    A16-2 (+B) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE