DTC P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0121 | Difference between voltage output of VTA1 and VTA2 deviates from the threshold for 2.0 seconds. | Throttle Position (TP) sensor (built into throttle body) |
| Related DTCs | P0121: Throttle Position (TP) sensor rationality |
| Required Sensors/Components (Main) | TP sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | Within 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever this DTC is not present | None |
| Either of following conditions is set | Condition A or B |
| A. Ignition switch | ON |
| B. Electric throttle motor power | ON |
| TP sensor malfunction (P0120, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |
| Different between VTA1 and VTA2 [VTA1 - (VTA2 x 0.8 to 1.2)]* * Corrected by learning value | Less than 0.8 V and more than 1.6 V |
| 1.READ OTHER DTC OUTPUT (IN ADDITION TO DTC P0121) |
Connect the intelligent tester to the DLC3 with CAN VIM.
Turn the ignition switch ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0121 | A |
| P0121 and other DTCs | B |
|
| ||||
| A | ||
| ||