Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > INSTALLATION

for Preparation Click here



1. INSTALL SPIRAL CABLE
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    If it is not in the neutral position, the pin of the turn signal switch may snap.



    H042178
  1. Install the spiral cable with the 4 screws.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

  1. Connect the connectors to the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL STEERING COLUMN COVER UPPER
  1. Install the steering column cover upper.



3. INSTALL STEERING COLUMN COVER LOWER


    H042177
  1. Install the steering column cover lower with the 3 screws.



4. ADJUST SPIRAL CABLE
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    After removing the terminal, wait for at least 90 seconds before starting the operation.



    H042179
  1. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.



    H042180E02
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



5. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and main shaft assembly.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. without Steering pad switch:
    Connect the connector.



6. INSPECT STEERING WHEEL CENTER POINT


7. INSTALL STEERING PAD


    H042354
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



8. INSTALL STEERING WHEEL COVER LOWER NO. 2
  1. Install the steering wheel No.2 cover lower.



9. INSTALL STEERING WHEEL COVER LOWER NO. 3
  1. Install the steering wheel No.3 cover lower.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. INSPECT STEERING PAD


    H042163
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



12. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).