Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL COVER LOWER NO. 3
  1. Using a screwdriver, remove the steering wheel No. 3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL COVER LOWER NO. 2
  1. Using a screwdriver, remove the steering wheel No. 2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD


    F043322
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042354
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screw driver, disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


    F043320E01
  1. without Steering pad switch:
    Disconnect the connector.

  1. Remove the steering wheel assembly set nut.

  1. Mark matchmarks on the steering wheel assembly and main shaft assembly.

  1. Set the SST on the steering wheel assembly.

  1. Holding the SST to the monkey spanner and turn the SST, then remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER LOWER


    H042177
  1. Remove the 3 screws and steering column cover lower.



9. REMOVE STEERING COLUMN COVER UPPER
  1. Remove the steering column cover upper.



10. REMOVE SPIRAL CABLE
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    H042178
  1. Disengage the 4 claws and remove the spiral cable.