Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B076922E02
  1. Using a screwdriver, disengage the claw labeled A, claw labeled B, 4 claws labeled C, claw labeled D and claw labeled E. Remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DOOR SCUFF PLATE LH


    B076924E01
  1. Using a screwdriver, disengage the claw labeled A, claw labeled B, 2 claws labeled C and claw labeled D. Remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH


6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


7. REMOVE LAP BELT OUTER ANCHOR COVER


8. REMOVE CENTER PILLAR GARNISH LOWER LH


9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


10. REMOVE SIDE AIRBAG SENSOR LH


    H042349
  1. Remove the 2 nuts and the side airbag sensor LH.

  1. Disconnect the connector from the side airbag sensor LH.