CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION |
| 1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Temporarily install the center airbag sensor assembly with the 3 bolts.
Tighten the 3 bolts to the specified torque.
Check that there is no looseness in the installation parts of the center airbag sensor assembly.
Connect the 3 connectors to the center airbag sensor assembly.
Check that the waterproof sheet is properly set.
| 2. INSTALL CONSOLE BOX DUCT NO. 1 |
| 3. INSTALL CONSOLE BOX MOUNTING BRACKET FRONT |
| 4. INSTALL CONSOLE BOX ASSEMBLY REAR |
| 5. INSTALL CONSOLE UPPER PANEL GARNISH NO. 2 |
| 6. INSTALL CONSOLE UPPER PANEL GARNISH NO. 1 |
| 7. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER |
| 8. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).