Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    C131378
  1. Install the front passenger airbag assembly with the 3 screws.



    C131377
  1. Install the 3 clamps.



2. INSTALL HEATER TO REGISTER DUCT NO. 2

HINT:
Click here



3. INSTALL DEFROSTER NOZZLE ASSEMBLY

HINT:
Click here



4. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

HINT:
Click here



5. CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR


    H042181
  1. Connect the connector to the front passenger airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. INSTALL STEERING COLUMN COVER UPPER


    F043298
  1. Install the steering column cover upper to the steering column assembly.



7. INSTALL STEERING COLUMN COVER LOWER

HINT:
Click here



8. ADJUST SPIRAL CABLE
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    After removing the terminal, wait for at least 90 seconds before starting the operation.



    H042179
  1. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.



    H042180E02
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



9. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and main shaft assembly.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. without Steering pad switch:
    Connect the connector.



10. INSPECT STEERING WHEEL CENTER POINT


11. INSTALL STEERING PAD


    H042163
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



12. INSTALL STEERING WHEEL COVER LOWER NO.2
  1. Install the steering wheel No.2 cover lower.



13. INSTALL STEERING WHEEL COVER LOWER NO.3
  1. Install the steering wheel No.3 cover lower.



14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


15. INSPECT STEERING PAD


    H042163
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



16. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).