Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL COVER LOWER NO. 3
  1. Using a screwdriver, remove the steering wheel No. 3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL COVER LOWER NO. 2
  1. Using a screwdriver, remove the steering wheel No. 2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD


    F043322
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042354
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screw driver, disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


    F043320E01
  1. without Steering pad switch:
    Disconnect the connector.

  1. Remove the steering wheel assembly set nut.

  1. Mark matchmarks on the steering wheel assembly and main shaft assembly.

  1. Set the SST on the steering wheel assembly.

  1. Holding the SST to the monkey spanner and turn the SST, then remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER LOWER


    F043298
  1. Remove the 3 screws and steering column cover lower.



9. REMOVE STEERING COLUMN COVER UPPER


10. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR


    H042181
  1. Disconnect the connector from the passenger airbag assembly connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



11. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

HINT:
Click here



12. REMOVE DEFROSTER NOZZLE ASSEMBLY
  1. Remove the 2 screws <D> and the defroster nozzle assembly.



13. REMOVE HEATER TO REGISTER DUCT NO. 2
  1. Remove the 5 screws <D> and the No. 2 heater to register duct.



14. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    C131377
  1. Disengage the 3 clamps.



    C131378
  1. Remove the 3 screws and the front passenger airbag assembly.



    C131326E01
  1. Release the rear side wall of the airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly forward.

  1. Release the front side wall of the airbag door from the other hook and remove the front passenger airbag assembly.