Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.

HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM


I033551E01


INSPECTION PROCEDURE

1.CHECK DLC3 (TC TERMINAL VOLTAGE)
F040034E31
  1. Turn the ignition switch to ON.

  1. Measure the voltage of the DLC3.

    Standard voltage:
    10 to 14 V



OK
Go to step 3
NG


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
  1. Check for open and short circuit in harness and connector between terminal CG of DLC3 and body ground (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BODY GROUND)
OK


3.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
  1. Check for open and short circuit in harness and connector between terminal TC of DLC3 and ECM (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

CHECK AND REPLACE ECM