Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

When turn the ignition switch to the ON position, the combination meter assembly communicates with the ECM by the direct line.

WIRING DIAGRAM


E118032E04


INSPECTION PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY


    E123279E02
  1. Check the input signal waveform.

    1. Remove the combination meter assembly with the connector(s) still connected.

    2. Connect the oscilloscope to the terminals C9-6 (TM INPUT) and body ground.

    3. Start the engine.

    4. Check the signal waveform according to the condition(s) in the table below.
      Item
      Condition
      Tool Setting
      5 V/DIV., 10 ms/DIV.
      Vehicle Condition
      Engine idle speed

      OK:
      The waveform is displayed as shown in the illustration.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY 

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)


    E113266E04
  1. Disconnect the C9 and E9 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    TACH (E9-1) - TM INPUT(C9-6)
    Always
    Below 1 Ω
    TM INPUT (C9-6) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM