Home › BODY ELECTRICAL › GARAGE DOOR OPENER › GARAGE DOOR OPENER SYSTEM

GARAGE DOOR OPENER SYSTEM > INSPECTION



1. INSPECT GARAGE DOOR OPENER


    B056159E01
  1. Press the switch and check that each red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness, then replace the garage door opener system unit.



2. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING

HINT:
Use the home link tester made by KENT MORE for this test. Because it is necessary to register the code of the hand-held transmitter, the customer's code should be erased. When the inspection is complete, register the customer's again.



    B056160E01
  1. Check if the tester transmitter code was successfully registered.

    HINT:
    If the code cannot be registered, replace the garage door opener system unit.



    B062199E02
  1. Press the garage door opener switch that was registered to the tester transmitter. Check if the "Home Link" tester's green LED illuminates.

    HINT:
    If the green LED does not illuminate, replace the garage door opener.